Sam4s ER-285M - Page 142

142 • Program Mode Reference Guide SAM4s ER-285M Operator's and Program Manual v1.4
Address SYSTEM OPTION VALUE = SUM
34
MSR Connected to
DataTran = 0
PDC = 1
Register = 2
35
PIN pad connected to device on:
Port 1 =
Port 2 =
Port 3 =
0
1
2
3
36
MCR Uses Digit (0-9)
(for employee cards)
0
37
Keyboard Level
numbering system
(see note 2 below):
Numbered by level =
Numbered by key =
0
1
Note 1
Using system option #30, you can set the store name for program and report backup/load data
to an SD card.
Note 2
In the default configuration (option 37=0):
• Level 1 accesses PLUs 1-15
• Level 2 accesses PLUs 16-30
An optional numbering method is available for PLUs and Levels. You may wish to consider
this option when you are using pop-up levels for sizes and you want different sizes of the
same item to be listed together on the PLU report. With this option selected:
• PLU #1 accesses PLU 1 on level 1, PLU 2 on level 2
• PLU #2 accesses PLU 3 on level 1, PLU 4 on level 2
• PLU #3 accesses PLU 5 on level 1, PLU 6 on level 2
and so on until:
• PLU #15 accesses PLU 29 on level 1, PLU 30 on level 2