Sam4s ER-430 SERIES - Program 150 - PLU Group Assignment Programming

148 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 150 - PLU Group Assignment Programming
Each PLU may report to any three levels of 20 groups. Group totals appear on reports, so that you can
track sales of different types of items. A group can also be used to designate items that are to print on
an optional kitchen printer.
NOTE: The PLU will report to group "0", if not programmed to report to groups 1-20.
Programming PLU/PLUs Group Assignment
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 1 5 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
• Press the first PLU in a range of PLUs that are to receive the same setting then press
the last PLU, or
• Enter up to 15 digit number of the PLU and press the PLU key, or
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last PLU number in the range; press the PLU
key, or
• For a barcode item, scan the barcode. (Only for single item.)
4. Enter up to three 2-digit numbers representing the groups where you wish to add the
PLUs sales, i.e. enter 1 0 for group 10 or enter 0 4 for group four. If a PLU is link to
group 03 as 1
st
group only, please enter 0 3 0 0 0 0. Then press the X/TIME key.
5. To program additional PLU Group Assignment, repeat from step 3, or press the CASH
key to finalise the program.
CASH
2
nd
Group 1
st
Group 3
rd
Group
X/TIME
PLU
PLU
PLU
PLU
Enter the PLU#,
up to 15 digits
PLU
Enter the first PLU#,
up to 15 digits
Enter the last PLU#,
up to 15 digits
PLU
0 SUBTL5 1