Sam4s ER-430 SERIES - Program 710 - Clerk Report Message Programming

230 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 710 - Clerk Report Message Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To descript by three digit alpha character codes you must select ‘No’ in
system option #25(for ER-3xx Series)/#30(for ER-230, ER-4xx and ER-52xx Series) (See
“System Option Programming). Also see Descriptor Programming Methods for Alpha Overlay
and/or Descriptor Code Table.
Programming the Clerk Report Message
The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk
Report totals and counters. For example, the first total on the clerk report "NET SALES"
might be re-labeled to say "GROSS SALES". You can reprogram any of the Financial Report
totals listed here with any 18-character descriptor. (See “Clerk Report Message”).
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 7 1 0, press the SUBTL key.
3. Refer to the chart below and enter the number that represents the line you wish to
program; press the X/TIME key.
4. If you are programming using alpha overlay, type up to 18 descriptors on the overlay
and press the SUBTL key
or,
If you are programming using descriptor codes, enter up to 18 three-digit character codes
and press the SUBTL key.
5. To program additional Clerk Report Message, repeat from step 3, or press the CASH
key to finalise the program.
CASH
Type up to 18 / 12 (ER-230)
descriptor keys
SUBTL
SUBTL
Enter up to 18 / 12 (ER-230)
three-character codes
X X/TIME
0 SUBTL1 7