Sam4s ER-430 SERIES - System Option Programming; Program 30 - System Option Programming

156 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to
determine if you wish to make any changes. Default value has been highlighted in bold print.
NOTE: Because after Memory All Clear all options settings are automatically set to default, you do
not need to program this section unless you wish to change the default status.
Program 30 - System Option Programming
Programming a System Option:
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. Enter 3 0, press the SUBTL key.
3. Enter a system option address, press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more than one
decision to be made in an address, add the values representing your choices for each
decision and enter the sum. Press the SUBTL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH key to end system option programming.
System Option Flowchart
ÚDefault values have been highlighted in bold print
SUBTLX/TIME
Status
CASH
Repeat for each System Option
Option #
SUBTL 0 3