220 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 810 - Clerk Description Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To descript by three digit alpha character codes you must select ‘No’ in
system option #25(for ER-3xx Series)/#30(for ER-230, ER-4xx and ER-52xx Series) (See
“System Option Programming). Also see Descriptor Programming Methods for Alpha Overlay
and/or Descriptor Code Table.
Programming the Clerk Descriptor
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 8 1 0, press the SUBTL key.
3. Enter the number of the clerk you wish to program; press the X/TIME key.
4. If you are programming using alpha overlay, type up to 18 descriptors on the overlay
and press the SUBTL key,
or,
If you are programming using descriptor codes, enter up to 18 three-digit character codes
and press the SUBTL key.
5. To program additional Clerk Descriptor, repeat from step 3, or press the CASH key to
finalise the program.
0 SUBTL1 8
CASH
Type up to 18 / 12 (ER-230)
descriptor keys
SUBTL
SUBTL
Enter up to 18 / 12 (ER-230)
three-character codes
X/TIME
To Next Page
Loading...
