Sam4s ER-430 SERIES - Program 400 - PLU Delete Programming

154 • Program Mode Programming Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU
Program 400 - PLU Delete Programming
NOTE: To delete a PLU, all totals for the PLU must be cleared from Z reports (including Stock and
PLU reports.)
Programming PLU/PLUs Deletion
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 4 0 0, press the SUBTL key.
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU on the keyboard, or
• Press the first PLU in a range of PLUs that are to receive the same setting then press
the last PLU, or
• Enter up to 15 digit number of the PLU and press the PLU key, or
• Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last PLU number in the range; press the PLU
key, or
• For a barcode item, scan the barcode. (Only for single item.)
4. Press X/TIME key.
5. To program additional PLU deletion, repeat from step 3, or press the CASH key to
finalise the program.
CASH
0 SUBTL0 4
PLU
PLU
PLU
PLU
Enter the PLU#,
up to 15 digits
PLU
Enter the first PLU#,
up to 15 digits
Enter the last PLU#,
up to 15 digits
PLU
X/TIME