Sam4s ER-430 SERIES - Program 711 - Macro Name Programming

Sam4S 230, 3xx, 4xx, 52xx Electronic Cash Register AU Program Mode Programming • 233
Program 711 - Macro Name Programming
Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To descript by three digit alpha character codes you must select ‘No’ in
system option #25(for ER-3xx Series)/#30(for ER-230, ER-4xx and ER-52xx Series) (See
“System Option Programming). Also see Descriptor Programming Methods for Alpha Overlay
and/or Descriptor Code Table.
Programming the Macro Name
Up to ten function locations may be designated as Macro keys. You may wish to program a
name for a macro. For example if a macro executes a series of commands to produce daily
reports, you can program the descriptor “DAILY”, so the macro can easily be identified.
Macro names can also be helpful when looking at keyboard layout information with the PC
communication utility.
1. Turn the control lock to the PGM-Mode.
Switch to P Mode by press MODE function key. (For ER-230)
2. To begin the program, enter 7 1 1, press the SUBTL key.
3. Refer to the chart below and enter the number that represents the Macro key you wish
to program; press the X/TIME key.
X Macro Key X Macro Key X Macro Key X Macro Key
1
Macro 1
4
Macro 4
7
Macro 7
10
Macro 10
2
Macro 2
5
Macro 5
8
Macro 8
3
Macro 3
6
Macro 6
9
Macro 9
4. If you are programming using alpha overlay, type up to 18 descriptors on the overlay
and press the SUBTL key
or,
If you are programming using descriptor codes, enter up to 18 three-digit character codes
and press the SUBTL key.
5. To program additional MACRO name, repeat from step 3, or press the CASH key to
finalise the program.
CASH
X X/TIME
1 SUBTL1 7
Type up to 18 / 12 (ER-230)
descriptor keys
SUBTL
SUBTL
Enter up to 18 / 12 (ER-230)
three-character codes