1.7 Setting party mode
Using the Party mode function, the controller continues or activates rated operation of the
controller during the time when the party timer is active, regardless of the adjusted
times-of-use. The party timer begins when the rotary switch has been returned to operating
mode “Automatic“. When the party timer has elapsed, the party function is reset to
00:00.
The party modes for the different control circuits are adjusted at the rotary switches one after
the other:
Party timer Rotary switch Position
Heating circuit 1* Top
Heating circuit 2* Middle
DHW circuit* Bottom
* Refer to page 121 for assignment
Parameter
WE Range of values
Continue/activate rated operation 0 h 0 to 48 h
Proceed as follows:
Turn appropriate rotary switch to “Party mode“.
Display shows:
00:00
or the remaining time of the adjusted party timer
q
Edit desired length of the one-off time-of-use.
Return the rotary switch to operating mode “Automatic“ (left side).
Note!
The time elapsing on the party timer is displayed in steps of 15 minutes.
EB 5575 EN 15
Operation
To Next Page
Loading...
