1.8.1 Setting public holidays
On public holidays, the times-of-use specified for Sunday apply. A maximum of 20 public
holidays may be entered.
Parameter
WE Level / Range of values
Public holidays – Extended operating level / 01.01 (1 Jan) to 31.12 (31 Dec)
Proceed as follows:
q
In extended operating mode, select “Public holidays“.
Display shows:
Open data point “Public holidays“.
q
If applicable, select
– – – –
.
Activate editing mode for public holiday. blinks.
q
Edit desired public holiday.
Confirm public holiday.
To enter additional public holidays, re-select
– – – –
and repeat the steps in the fields high-
lighted in gray.
Exit data point “Public holidays“.
Note! Public holidays can also be adjusted in parameter level PA5 (–> section 2.3).
Deleting a public holiday:
q
Under data point “Public holidays“, select the holiday you wish to delete.
Confirm selection.
q
Select
– – – –
.
Delete the public holiday.
Note!
Public holidays that are not assigned to a specific date should be deleted by the end of the
year so that they are not carried on into the following year.
EB 5575 EN 17
Operation
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
To Next Page
Loading...
