Samsung CLX-9250ND - Lift Motor

3. Replaceme
n
3.7.10 Lift motor
Perform the following procedure to remove the 2 Lift M
o
1. Remove the HVPS board (front). (refer to 3.7.9)
2 There are 2 identical lift motors To remove a lift mot
2
.
There
are
2
identical
lift
motors
.
To
remove
a
lift
mot
3.7.11 SMPS PBA
1. Remove the rear cover. (refer to 3.2.4)
2. Remove the 6 screws from the SMPS box.
Perform the following procedure to remove the MPS
P
Service Manual
CLX-9250/9350 series
3-
6
n
t Procedures
o
tors from the printer.
or remove 3 screws and 1 connector
or
,
remove
3
screws
and
1
connector
.
3. Take off the SMPS board after removing 7
screws and all connectors.
P
BA from the printer.
SAMSUNG ELECTRONICS
6
6