Samsung CLX-9250ND - TR Control Mode

4.Servi
c
4.6.8. TR Control Mode
• Service Functions > TR Control Mode
Purpose To correct transfer related prob
transfer value to o
p
timize ima
ge
pg
Operation
Procedure
1. T1 Control Problems
• Choose the process speed
be used.
•
A
djust T1 PWM value bas
e
 Gray Spot : Increa
s
 Non Cyclic White
L
 OPC Cyclic Ghost
2. T2 Control Problems
• Choose the paper group, p
a
•
A
djust T1 PWM value bas
e
 Blur : Increase T1
P
 Poor Transfer : Inc
r

Re
-
transfer : Decre
Gray Spot
N
o
Re
transfer
:
Decre
 White Spot : Decre
3. Blur Upgrade Mode : Turn o
n
4. OHP Upgrade Mode : Turn
o
Note that this option needs to b
OHP i ti M t f OHP t
Blur
OHP
pr
i
n
ti
ng.
M
os
t
o
f
OHP
t
yp
e
Verification Print out a test job and make s
u
Specification N/A
Reference N/A
Service Manual
CLX-9250/9350 series
4-
4
c
e Mode
lems. This function can be used to change the
e
q
ualit
y
to a certain t
yp
e of
p
a
p
er.
qy yppp
(Full, Half, Lower) based on the type of paper to
e
d on the problem type.
s
e T1 PWM value of the issued color
L
ine : Decrease T1 PWM value of the issued color
: Decrease T1 PWM value of the issued color
a
per side, and paper direction.
e
d on the problem type.
P
WM value
r
ease T1 PWM value
ease T1 PWM value
OPC Cyclic Ghost
o
n Cyclic White Line
ease
T1
PWM
value
ase T1 PWM value
n
the mode when black lines becomes blur.
o
n the mode when transfer on OHP becomes poor.
e turned on only if there is a transfer problem in
bdithtthititd
Poor Transfer
White Spot
e
s can
b
e use
d
w
ith
ou
t
thi
s op
ti
on
t
urne
d
on.
u
re the transfer problem has resolved.
SAMSUNG ELECTRONICS
4
8