Samsung CLX-9250ND - Side Joint Board

3. Replaceme
n
3.7.14 Side joint PBA
1. Open the side unit.
Perform the following procedure to remove the Ozone
2. Release the side joint board cover after removing
2 screws.
Push !
Service Manual
CLX-9250/9350 series
3-
7
n
t Procedures
3. Unplug all connectors.
4 Remove 4 screws
Filter Fan from the printer.
4
.
Remove
4
screws
.
5. Release the side joint board.
CAUTION
When you reassemble the side joint board to the
side unit, make sure the harness arrangement is
correct.
The harness on the side joint board
The
harness
on
the
side
joint
board
.
The harness of Face up Sensor.
SAMSUNG ELECTRONICS
7
0