Samsung CLX-9250ND - HVPS Board

3. Replaceme
n
3.7.9 High Voltage Power Suppl
y
Perform the following procedure to remove the HVPS
P
NOTE – This model has 2 HVPS boards.
1. Open the video/engine shield door.
2. Remove the Lower Rear Cover after removing 5
screws.
3. Unplug 2 connectors.
CAUTION
CAUTION
When unplugging this connector, be careful not to
hlf
Observe precautions
For handling
Electrostatic
Sensitive
Devices
Service Manual
CLX-9250/9350 series
3-
6
get
h
urt yourse
lf
.
n
t Procedures
y
(HVPS) PBA
P
BA from the printer.
4. Remove 5 screws.
5. Put the SMPS box [A] down as shown below.
[
A
]
[]
SAMSUNG ELECTRONICS
6
3