Samsung CLX-9250ND - Transfer Belt Drive

2. Product
d
2.5.3.2 Transfer belt drive
The ITB drive motor [A] drives the image transfer belt
drive roller [C]. The speed of ITB drive depends on th
This printer uses the rotation encoder to control the tr
a
guide rollers [B]. This encoder checks the rotation sp
e
analyzes the signals from the encoder. Then it adjust
s
The encoder contains a disk that has 550 notches on
i
The controller counts the number of notches that the
s
read an unusuall
y
lar
g
e number of notches or an unu
s
yg
such unusual signals. Therefore, an incorrect reading
[
C
[A]
[B]
Service Manual
CLX-9250/9350 series
2-
3
d
escription
[B] and the Cleaning unit by using gears and the ITB
e process line speed.
[A]
[B]
[C]
a
nsfer belt speed. The encoder [A] is on one of the
e
ed of the image transfer belt. The controller
s
the rotation speed of the image transfer belt.
i
ts surface. These notches are read by the sensor [C].
s
ensor has read in the unit of time. If the sensor has
s
uall
y
small number of notches
,
the controller i
g
nores
y,g
does not affect the rotation speed.
C
]
SAMSUNG ELECTRONICS
3
7