Samsung CLX-9250ND - Nd Transfer Roller

7. Trouble
s
● Code :
M2-1331
M2-1333
M2-1334
● Error message :
Paper jam inside of
m
● Symptom / Cause : Paper transport jam (paper In
p
- The paper has not reached the fuser out sensor wit
h
- The fuser out sensor is not off within normal time aft
e
● Troubleshooting method :
1. O
p
en the side door. Remove the
j
ammed
p
a
p
er.
pjpp
Close the side door. After warm up, if same jam oc
c
2. If there is any obstacles between the tray1 feed roll
e
3. If the 2
nd
transfer roller or assembly is damaged, re
p
4 If th bl i t t th id it f
4
.
If
th
e pro
bl
em pers
i
s
t
s, separa
t
e
th
e s
id
e un
it
f
rom
s
5. If Cam, lever, spring of the 2
nd
transfer roller engag
e
6. If the actuator-fuser out, guide-face up exit are dam
a
7. Enter the dia
g
nostic mode
,
and execute the fuser o
u
g,
Fix the actuator and be the paper at sensor. If “With
o
sensor.
8. Check if the fuser out sensor connector is connecte
d
9. Replace the Joint PBA of the side unit.
10. Replace the harness of the side unit.
11. Check if the connector of the engine controller is c
o
12. Replace the engine controller PBA.
●
Replacement part
●
Replacement
part
- JC95-01038A : COVER-SIDE TRANSFER ROLLER
- JC92-02233A : SIDE JOINT
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
8
s
hooting
m
achine.
p
ut section)
h
in normal time after passing the regi sensor.
e
r the fuser out sensor on.
c
urs, check the following.
e
r and the regi roller, remove it.
p
lace it.
tAd h kth fll i
s
e
t
.
A
n
d
c
h
ec
k
th
e
f
o
ll
ow
i
ng.
e
device are damaged, replace them.
a
ged, replace them.
u
t sensor test.
o
ut paper” message is displayed, replace the
d
properly. Reconnect the connector.
o
nnected properly. Reconnect the connector.
SAMSUNG ELECTRONICS
8
4