Samsung CLX-9250ND - Page 365

7. Trouble
s
● Code :
A3-2110
● Error message :
A
ctuator Sensor Fai
l
● Symptom / Cause :
Calibration for density sensor is failed
● Troubleshooting method :
1. Check if the driving section of the developer is oper
a
2. Enter the Service mode. Check the TC value.
(Diagnostics > Engine Diagnostics > Engine Test R
o
3. If TC value is not proper range. (TC Value : 80~1
2
- Replace the imaging unit.
● Replacement part
K Ima
g
in
g
Unit : CLT-R607K
gg
C Imaging Unit : CLT-R607C
M Imaging Unit : CLT-R607M
Y Imaging Unit : CLT-R670Y
Service Manual
CLX-9250/9350 series
7-
2
s
hooting
l
ure #A3-2110: Turn off then on.
a
ted properly.
o
utines > 111-5000 / 5010 / 5020 / 5030)
2
0)
SAMSUNG ELECTRONICS
2
5