Samsung CLX-9250ND - Page 375

7. Trouble
s
● Code :
C1-2411
C1-3411
C1-4411
C1-5411
● Error message
:
Yellow toner cartrid
g
Magenta toner cartr
Cyan toner cartridg
e
Black toner cartridg
e
● Symptom / Cause :
The data of CRUM is not detected.
1. Toner cartridge is not placed in the set.
2. Physical obstacle is jamming the electronic signal t
h
3. The signal from set is not proper.
● Troubleshooting method :
1. Open the front cover.
Remove the waste toner container.
Open the inside cover.
2 Is the toner cartridge placed in the set or not?
2
.
Is
the
toner
cartridge
placed
in
the
set
or
not?
YES! NO! → Place the toner cartridge in the set
↓
Pull out the imaging unit and check the modular j
a
Is there any contaminations or obstacles?
YES! NO! → Is the modular jack fixed in proper
p
↓ YES! NO! → Replace the toner car
t
↓ ↓
↓ Check whether the electronic signal i
s
↓
Sweep the contaminations or remove the obstacle
s
Install the toner cartridge and do the reverse of No
Is there the error message?
YES! NO! → It
’
s done
YES!
NO!
→
It s
done
.
↓
Check whether the electronic signal is proper or n
o
● Replacement part
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
- JC92-02292A : PBA-TONER CONNECTOR
- JC92-02164A : PBA TONER CRUM JOINT
- JC41-00543A : PCB TONER CONNECTOR
Service Manual
CLX-9250/9350 series
7-
3
s
hooting
:
g
e is not installed. Install it.
idge is not installed. Install it.
e
is not installed. Install it.
e
is not installed. Install it.
h
rough the modular jack.
.
a
ck.
p
osition?
t
ridge with new one.
s
proper or not.
s
.
.1.
o
t. Check the connector and engine board.
SAMSUNG ELECTRONICS
3
5