Samsung CLX-9250ND - Page 409

7. Trouble
s
● Code :
H1-1311
H1-1317
H1-1318
● Error message :
Paper jam inside of
m
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper from the tray3 has not reached the tray3 f
e
feed sensor.
- When you open and close the take away (DCF, HCF
sensor.
●
Troubleshooting method :
●
Troubleshooting
method
:
1. Open the side & take away door. Remove the jam
m
Close the Side door. After warm up, if same jam oc
c
2. Open the side & take away. Remove the jammed p
a
and tray2 feed roller. If there is any defective part in th
3. If the white idle roller of the take away door breaks
a
roller.
4. Check if the wall connector of tray3 pick up unit is c
o
5. Enter the dia
g
nostic mode
,
and check the feed sen
s
g,
If the paper is at sensor and “Without paper” messa
g
6. Check if the connector of the tray3 pick up unit on t
h
it.
7. Replace the DCF (or HCF) controller.
● Replacement part
- JC95-01034A (COVER-TAKE AWAY)
- JC93-00070A (FRAME MAIN-PICK UP)
- JC93-00174A (FRAME MAIN-PICK UP SECOND)
Service Manual
CLX-9250/9350 series
7-
6
s
hooting
m
achine.
e
ed sensor within normal time after passing the tray4
) door, the paper has jammed at the tray3 feed
m
ed paper.
c
urs, check the following.
a
per between the feed roller of the tray3 pick up unit
is area, replace it.
a
way, release the inner cover and reassemble the idle
o
nnected properly. Reconnect the connector.
s
or test of the tra
y
1
p
ick u
p
unit.
yp p
g
e is displayed, replace the sensor.
h
e pick up drive unit is connected properly. Reconnect
SAMSUNG ELECTRONICS
6
9