Samsung CLX-9250ND - Page 411

7. Trouble
s
● Code :
H1-1322
H1-1422
M1-3122
● Error message :
Tray 3 is pulled out.
Tray 4 is pulled out.
Tray 1 is pulled out.
M1-3222 Tray 2 is pulled out.
● Symptom / Cause :
Tray No. LED is on.
- Tray 1 (2,3,4) is pulled out or the auto size sensor c
o
● Troubleshooting method :
1. Insert the corresponding cassette perfectly.
2. If the cassette is not locked or pulled out without ho
l
3. Check if the auto size sensor is connected properly
.
4. Check if the connector on the Joint PBA is connect
e
5. Replace the engine controller PBA.
● Replacement part
- JC92-02129A : PBA-ENGINE (CLX-9350ND)
- JC92-02239A : PBA-ENGINE (CLX-9250ND)
Service Manual
CLX-9250/9350 series
7-
7
s
hooting
Insert it properly.
Insert it properly.
Insert it properly.
Insert it properly.
o
nnector is not connected or broken.
l
ding the locking lever, reassemble the cassette.
.
Reconnect or replace it.
e
d properly. Reconnect or replace it.
SAMSUNG ELECTRONICS
7
1