● Code :
U2-2112
U2-3112
U2-4112
U2-5112
● Error message
● Symptom / Cause :
Yellow LSU does not operate but L-ready signal is de
Magenta LSU does not operate but L-ready signal is
Cyan LSU does not operate but L-ready signal is det
Black LSU does not operate but L-ready signal is det
● Troubleshooting method :
1. Turn the machine on and turn it off again.
Has the error message disappeared?
2. If the problem persists, check the following :
A. If the finisher is installed, remove it.
B. Remove the left cover.
C. Check if the Motor connector on Joint PBA of the
D. Remove the LSU unit from the machine. Remov
is connected correctly.
E. Enter the diagnostic mode. Execute LD test. Che
3. If the problem persists, replace the LSU unit.
● Replacement part
JC97-03605A : LSU (35 ppm)
JC97-03605B : LSU (25 ppm)
Service Manual
CLX-9250/9350 series
7-1
lure #U2-2112 : Turn off then on.
ailure #U2-3112 : Turn off then on.
re #U2-4112 : Turn off then on.
re #U2-5112 : Turn off then on.
cted.
LSU unit is connected correctly.
the left cover and check if the LSU Motor connector
ck if L-Ready not occurs.
SAMSUNG ELECTRONICS
34