Samsung CLX-9250ND - Page 51

2. Product
d
2.5.2.3 Phase Control Mec
h
The printer uses the drum gear position sensors to de
t
mode shows when it detects that the drum motor is n
o
initialize the relative positions of the gears when the
m
prevents phase fluctuation between printouts caused
b
There is an interrupter on each drum gear. The drum
g
interrupters. This mechanism makes sure that output
q
Immediately after the printer power turns on, recovers
opened and closed, the printer executes the drum ph
a
occurs:
• When a new imaging unit is installed.
• When a new cartridge transfer belt unit is installed.
A
lso, when the printer detects a shift in the drum posit
executes the drum phase adjustment.
2524 D l t
2
.
5
.
2
.
4 D
eve
l
opmen
t
[A] Developme
n
This printer uses a dual-component development syst
e
the drum units; one for each color). Each new unit co
n
in each unit is supplied to the magnetic roller [A] by th
e
surface of the roller. The diameter of the magnetic rol
Each imaging unit has a TD(Toner Developer) sensor
controlling the operating range of toner density. The i
m
Service Manual
CLX-9250/9350 series
2-
3
information about the imaging unit is stored.
d
escription
h
anism
t
ect whether the drum motors are rotating. Diagnostic
o
t moving. These sensors also help the printer to
m
ain switch is turned on, and during initializing. This
b
y incorrect gear meshing at the start of the job.
g
ear position sensors detect the positions of these
q
uality does not vary.
from the energy saver mode, or the front door is
a
se adjustment if one of the following conditions
ions during the line position adjustment, the printer
n
t Roller
[B]
Mixing
[C] TD
Sensor
Mixing
Auger
Sensor
[
B
]
Mixin
g
Au
g
er
[] g g
e
m and has four imaging units (which are included in
n
tains 330g of magnetic toner carrier. The developer
e
two mixing augers [B] and is attracted onto the
ler is 18 mm.
[C]. The TD sensor [C] in the imaging unit is used for
m
aging unit is equipped with a CRUM in which some
SAMSUNG ELECTRONICS
3
4