Samsung CLX-9250ND - Page 61

2. Product
d
2.7.2 Laser Scanning Optic
a
K C M
[A]
[C] [D] [D] [C]
The laser beam from the LSU is placed at intervals of
polygon motors. F2 Lens [A] determines the slope of
t
the secondary scanning direction. This is adjusted at
t
SET difference is adjusted by Skew adjustment in the
the primary scanning. The LSU has 2 types dependin
printer models is shown in the table below:
Mode CLX-9250ND(25ppm)
LD Unit
Laser Diode : Single Beam
driving IC : for Single LD
P/Motor speed 19,016 rpm
Process Speed
115 mm/sec
Process
Speed
115
mm/sec
H/W interface
KC Harness : 26 Pin
MY Harness : 24 Pin
Interface with set : 40 Pin
Service Manual
CLX-9250/9350 series
2-
4
d
escription
a
l path
Y
104mm for each color. All colors use the same
t
he primary scanning line and the image position of
t
he factory. The primary scanning line slope by the
LSU. Reflecting mirrors [C], [D] for each color adjust
g on printing speed. The difference between the two
CLX-9350ND(35ppm) Remarks
Laser Diode : Dual Beam
driving IC : for Dual LD
27,165 rpm
161 mm/sec
161
mm/sec
KC Harness : 34 Pin
MY Harness : 32 Pin
Interface with set : 40 Pin
SAMSUNG ELECTRONICS
4
4