Samsung FP-T5894W - Basic TV Operation; Powering On;Off and Plug & Play Setup

IOperation
I
Turning the TV and Wireless Home AV Center On and Off
Press the POWER button on the remote control.
The TV and Wireless Home AV Center will be turned on and you will
be able to use their features. You can also use the Power button
on the front of the TV
~ If your TV isn't turned on when the Power button is pressed:
Press the TV button to check if the TV mode has been chosen.
----~---cmm---i:ID------
a 00 ®, SOURCE
O
.".o~~ .
----~---~---~---~------
If you install the TV and the Wireless Home AV Center and turn them on, the TV and the Wireless Home AV Center
are automatically connected.
~ The Wireless Home AV Center does not have any controls or buttons (ie Power). When the TV is turned on, the
Wireless Center will also turn on automatically.
I Plug & Play Feature
1 Press the POWER button on the remote control.
The message Connecting to Wireless Home AV Center is displayed.
2 Press the ENTER button, the Select the language of the OSD menu is
automatically displayed.
Press the .& or " button to select language, then press the ENTER button.
The message Select Home Mode when installing this TV at home. is
automatically displayed.
3 Press the .... or ~ button to select Shop or Home, then press the ENTER
button.
~ The default selection is Home.
~ We recommend setting the TV to Home mode for the best picture in your
home environment.
~ Shop mode is only intended for use in retail environments.
~ If the unit is accidentally set to Shop mode and you want to return to
Dynamic (Home) mode, press any Volume button and then hold down the
MENU button for five seconds on the TV panel.
4 Press the .& or " button to memorize the channels of the selected connection.
Press the ENTER button to select Start.
~ If the antenna is connected to ANT1 IN(AIR), select Air and if it is connected
to ANT 2 IN(CABLE), select Cable.
~ If both ANT 1 IN(AIR) and ANT 2 IN(CABLE) are connected,
select the Air + Cable.
~ In Cable mode, select the correct analog signal cable system source among
STD, HRC and IRC by pressing the .& or " button, then press the ENTER
button. If you have Digital cable, select the cable system signal source for
both Analog and Digital. Contact your local cable company to identify the
type of cable system that exists in your particular area.
To memorize the channels, press the ~ button to select Start, then press
the ENTER button.
Contact your local cable company to identify the type of cable system that
exists in your particular area.
Continued ...