Samsung FP-T5894W - Screen Burn Remediation and Help; Reducing Screen Burn Effects and Function Help

I
Reducing the Effects of Screen Burn
If screen burn has occurred, you can select a white screen or scrolling to help remove screen burn artifacts.
I
Press the MENU button to display the menu,
Press the • or 'f button to select Setup, then press the ENTER button.
2 Press the. or 'f button to select Screen Burn Protection, then press the
ENTER button.
3 Press the. or 'f button to select White, Scrolling or Side Gray
then press the ENTER button,
Press the EXIT button to exit.
White
This function removes after-images on the screen by changing the color of pixels to
white, Use this function when there are remaining after-images or symbols on the
screen especially when you displayed a still image on the screen for a long time,
Scrolling
This function removes after-images on the screen by moving all the pixels on the
Plasma TV according to a pattern. Use this function when there are remaining
after-images or symbols on the screen especially when you displayed a still image
on the screen for a long time.
Side Gray
When you watch TV with the screen ratio of 4:3, the screen is prevented from any
damage by adjusting the white balance on both extreme left and right sides,
To prevent the screen burn from happening, select Dark or Light.
• Dark: When you set the screen ratio to 4:3, it darkens the left and right sides,
• Light: When you set the screen ratio to 4:3, it brightens the left and right sides,
>- To remove after-images on the screen, use either the White or Scrolling
function, Although both functions remove after-images on the screen, Scrolling
is more effective,
>- The after-image removal function has to be executed for a long time
(approximately 1 hour) to effectively remove after-images on the screen. If the
after-image is not removed after performing the function, repeat the function
again,
>- Press any key on the remote control to cancel this feature.
Setting the Function Help
Displays help on the menu functions.
1
Press the MENU button to display the menu,
Press the. or 'f button to select Setup, then press the ENTER button.
2 Press the. or 'f button to select Function Help, then press the ENTER
button,
3 Press the. or 'f button to select Off or On, then press the ENTER button.
Press the EXIT button to exit.
>- The Function Help default setting is On,
,English-~ ,