Samsung FP-T5894W - Photo (JPEG) Viewing; Using the Photo List

I
Using the Photo (JPEG) List
You can play back the JPEG files saved on a memory device in various ways.
1
After switching the mode to WISELlNK, select the memory device that you have
inserted. (Refer to page 65)
2 Press the ..... or ~ button to select Photo, then press the ENTER button.
JPEG files and existing folders are displayed.
3 Press the A/T I ..... /~ buttons to select a file, then press the ENTER button.
)0;- Pressing the button over a photo icon displays the currently selected photo
in full screen. However, JPEG files smaller than 640x480 pixels are
zoomed-in at 4 times their original size. (e.g. If a photo's original size is
200x200 pixels, it is displayed at 800x800 pixels.)
)0;- Press the INFO button and select View to view a photo image at its original
size.
)0;- Pressing the button over a folder icon shows the JPEG files included in the
folder.
)0;- While a full screen is displayed, ..... or ~ buttons will let you see another
photo image in the same folder.
)0;- Press the PLAY/PAUSE button when a Photo icon is selected to start a Slide
Show.
To exit WISELINK mode, press the WISELINK button on the remote control.
)0;- Moving to a photo may take a few seconds because the file needs to be
loaded. At this point, the icon will appear.
)0;- This menu shows only the files whose extension is jpeg (or jpg).
Files with other formats such as gif or tiff will not be displayed.
)0;- Fifteen thumbnail photos are displayed per page.
)0;- The thumbnails are numbered from left to right and from top to bottom, from
1 to 15.
)0;- Folders are displayed first and they are followed by all JPEG files in the
current folder. The folders and JPEG files are sorted in alphabetical order.
)0;- If the photo is displayed in full screen, you can zoom in and out or rotate the
photo on the screen. (Refer to pages 70-71)
)0;- It takes a while to show JPEG files as thumbnail images.
)0;- WISELINK for this product supports JPEG files up to 8K x 8K pixels. For
progressive JPEG files or files whose size exceeds 8MB, the photo will be
displayed as a thumbnail only. When trying to view a progressive JPEG file,
the message Not supported mode will appear. When trying to view a file
exceeding 8MB, the message This file is too large to decode will appear.
)0;- The higher the image resolution advances, the longer the display time takes.
)0;- You cannot decode images beyond a horizontal resolution of 5000.
)0;- You cannot decode images beyond a vertical resolution of 4000.
[5J Press the WISELINK button on the remote control to turn on the WISELINK mode.
,:1a.- : Folder icon
.: Photo icon
: Move to the previous
folder stage icon
----\:J--\V--'C:./-----
ANTENNA CH LIST WISEltNK HOMI
9Qpg~1?
----~---~---~---""'-~----