Samsung FP-T5894W - Changing Channels

If you want to reset this feature ...
1 Press the MENU button to display the menu.
Press the .& or T button to select Setup, then press the ENTER button.
2 Press the ENTER button to select Plug & Play. For further details on setting up
options, refer to the page 18-19.
» The Plug & Play feature is only available in the TV and DTV mode.
I; Changing Channels
1 Press the CH A or CH v button to change channels.
» When you press the CH A or CH v button, the TV changes channels in
sequence. You will see all the channels that the TV has memorized.
(The TV must have memorized at least three channels). You will not
see channels that were either erased or not memorized. See page 22 to
memorize channels.
Using the Number Buttons
1
Press the number buttons to go directly to a channel. For example, to select
channel 27, press 2, then 7.
The TV will change channels when you press the second number.
Using the "-" Button
The "-" button is used to select stations that broadcast a digital signal.
For example, for Channel 7-1, press 7, then -, then 1.
» HD indicates the TV is receiving a Digital High Definition signal.
SD indicates the TV is receiving a Standard Definition signal.
» For quick channel change, press the number buttons, then press the ENTER
button.
Using the PRE-CH Button to select the Previous Channel
Use the number buttons to quickly tune to any channel.
1 Press the PRE·CH button. The TV will switch to the last channel viewed.
» To quickly switch between two channels that are far apart, tune to one
channel, then use the number button to select the second channel.
Then use the PRE·CH button to quickly alternate between them.
TV"~~
t- t·P!~g:.~j~J.?i:.. ._._______ _ ~J
Language . English ~
~me ~
V-Chip ~
Caption ~
Menu Transparency Medium ~
Blue Screen Off ~
• More
¢ - MOve GI' Enter a Reii'iiil
'1 i\: Menu language Shop Mode.
• Channels and ~me Will be set
~