I
Upgrading
the
Software
Samsung may
offer
upgrades
for
firmware
of
your
TV
or
Wireless Home
AV
Center in the future.
Please
contact
the Samsung call center at 1·800·SAMSUNG
to
receive information
about
downloading
upgrades
and using a USB drive.
To
upgrade the Wireless Home
AV
Center
1 Insert a
USB
drive containing the firmware upgrade into the
USB
Upgrade Port
on
the front panel of Wireless Home
AV
Center.
2 Press the MENU button
to
display the menu. Press
the'"
or
...
button
to
select
Setup, then press the ENTER button.
3 Press
the'"
or button
to
select SW Upgrade, then press the ENTER button.
4 Press
the'"
or button
to
select
AV
Center USB, then press the ENTER
button.
The message Scanning
for
USB
...
It may take up
to
30
seconds.
is
displayed.
5 If the firmware
on
the
USB
is
properly recognized, the message Upgrade
version
xxxx
to
version
xxxx?
The system would
be
reset after upgrade
is
displayed.
Press
the'"
or
~
button
to
select OK, then press the ENTER button.
The upgrade starts. Please
be
careful not
to
disconnect the power or remove the
USB drive while upgrades are being applied.
The Wireless Home
AV
Center will shut off
and
turn
on
automatically after
completing the firmware upgrade.
To
upgrade the TV
1 Insert a
USB
drive containing the firmware upgrade into the SERVICE port
on
the rear panel of the
TV.
2 Press the MENU button
to
display the menu. Press
the'"
or
...
button
to
select
Setup, then press the ENTER button.
3 Press
the'"
or button to select SW Upgrade, then press the ENTER button.
4 Press the
...
or button to select TV USB, then press the ENTER button.
The message Scanning
for
USB
...
It may take
up
to
30
seconds.
is
displayed.
5 If the firmware
on
the
USB
is
properly recognized, the message Upgrade
version xxxx
to
version
xxxx?
The system
would
be reset after upgrade.
is
displayed.
Press
the'"
or
~
button
to
select OK, then press the ENTER button.
The upgrade starts. Please
be
careful not
to
disconnect the power or remove
the
USB
drive while upgrades are being applied. The TV will shut off
and
turn
on
automatically after completing the firmware upgrade.
~
When software
is
upgraded, video
and
audio settings
you
have made will return
to
their default (factory) settings.
We
recommend
you
write down your settings
so
that
you
can
easily reset them after the upgrade.
Front
Panel
of
Wireless
Home
AV
Center
r1
USB (Not supplied) l.'
Rear
Panel
of
TV
~",.,
~'''~I
0
-~~
.
_....J~!tt
_
Scannmg for
USB
It may take up to
30
seconds
~--~---
Upgrade version XXXX to version XXXX ?
The system would be reset after upgrade
-----------
ro~
rcaneer
To Next Page
Loading...
