Samsung FP-T5894W - PIP Window Management; PIP Position, Channel Selection, and Freezing Picture

Changing the Position of the PIP Window
4
Press the'" or ,. button to select Position, then press the ENTER button.
Press the'" or ,. button to select the desired PIP window position, then press
the ENTER button.
~ In Double Window ( IT] ) and Double Wide ( [J::J ) modes, Position cannot
be selected.
~ If the PIP window is set to Double Window ( IT] ) or Double Wide ( [J::J )
mode, the screen size or alignment may slightly differ depending on the
signal type.
Changing the PIP Channel
5
Press the'" or ,. button to select Channel, then press the ENTER button.
Press the ... or ,. button at the bottom of the remote to select the desired
channel in the PIP window, then press the ENTER button.
~ MAIN: HDMI 1,2,3/ Component 1,2
PIP: TV(Analog)
Press the EXIT button to exit.
~ Press the PIP CH A and CH V buttons on the remote control to change the PIP
channel.
~ Normal sound will still be heard. Press again to cancel.
~ To prevent screen burn-in, this function will automatically cancel after 5
minutes.
~ While V-Chip is in operation, the Still function cannot be used.
..... [--8--~--6--~--lr--
FAY.CH AUTOPROG. ADDIOEl ~~I
CJCJCJldb)
_____ _ D~<;,,\. OIl~J:n. JJ _