I
•.
Connecting Cable
TV
To
connect to a cable
TV
system, follow the instructions below.
Cable without a Cable Box
1 Plug the incoming cable into the ANT 2 IN(CABLE) terminal
on
the back of the
Wireless Home
AV
Center.
~
Because this Wireless Home
AV
Center
is
cable-ready, you do not need a cable
box to view unscrambled cable channels.
Connecting to a Cable Box that Descrambles All Channels
1 Find the cable that
is
connected to the ANT OUT terminal
on
your cable box.
~
This terminal might be labeled "ANT OUT", "VHF OUT" or simply, "OUT".
ANT
IN
ANT OUT
iJ;Ur
t--=--~~
2 Connect the other end of this cable to the ANT 2 IN(CABLE) terminal
on
the back of
the Wireless Home
AV
Center.
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such
as
premium channels), follow the instructions below.
You
will need a two-way splitter,
an
RF
(AlB) switch and four lengths
of
Antenna cable. (These items are available
at most electronics stores.)
Splitter
Incoming
cable
-----...~-a
cable
Splitter
3 Connect
an
Antenna cable between
an
OUTPUT terminal
on
the splitter and the
IN
terminal
on
the cable box.
1 Find and disconnect the cable that
is
connected to the ANT
IN
terminal
on
your
cable box.
~
This
terminal
might
be
labeled
"ANT
IN",
"VHF
IN"
or
simply,
"IN".
2 Connect this cable to a two-way splitter.
Cable
Box
Cable
Box
4 Connect an Antenna cable between the
ANT OUT terminal
on
the cable box and the
B-IN
terminal
on
the RF(AlB) switch.
!--In·~~·~·I~n·g
-~-Irn~.....r"~""l
~~-,
..
-",-"
->,r~]~
~a
Splitter
l .
RF
(AlB)
Switch
5 Connect another cable between the other
OUT terminal
on
the splitter and the
A-IN
terminal
on
the
RF
(AlB) switch.
!------<=-r[]L.....r"»=---.'
omr
...
,~!
'"
~Ia
Incoming
~
cable
0
Splitter
,-=~-~=r-'
RF
(AlB)
Cable
Box
Switch
6 Connect the last Antenna cable between
the OUT terminal
on
the
RF
(AlB) switch
and the ANT 2
IN
(CABLE) terminal
on
the
back of the Wireless Home
AV
Center.
Incoming
cable
Splitter
After you have made this connection, set the AlB switch to the
"A"
position for normal viewing. Set the AlB switch to the
"B"
position to view scrambled channels. (When you set the AlB switch to
"B",
you
will need to tune your Wireless Home
AV
Center to the cable box's output channel, which
is
usually channel 3 or 4.)
To Next Page
Loading...
