Storing Channels Automatically
You can scan for the frequency ranges available to you
(availability depends on your country).
Automatically allocated programme numbers may not
correspond to actual or desired programme numbers.
However you can sort numbers manually and clear any
channels you do not wish to watch.
1 Press the MENU button to display the menu.
2 Press the ▲ or ▼ button to select Channel, then press the
ENTER/OK button.
3 Press the ▲ or ▼ button to select Auto Store, then press
the ENTER/OK button.
4 Press the ENTER/OK button again to start the search.
The search will end automatically.
➢
To stop the search before it has finished, press the MENU or the ENTER/OK button.
Checking the Digital-Signal Strength - Digital
Unlike analog channels, which can vary in reception quality
from “snowy” to clear, digital (HDTV) channels have either
perfect reception quality or you will not receive them at all.
So, unlike analog channels, you cannot fine tune a digital
channel.
You can, however, adjust your antenna to improve the
reception of available digital channels.
1 Press the MENU button to display the menu.
2 Press the ▲ or ▼ button to select Channel, then press the
ENTER/OK button.
3 Press the ▲ or ▼ button to select Signal Strength, then
press the ENTER/OK button.
4 If the signal strength meter indicates that the signal is
weak, physically adjust your antenna to increase the
signal strength.
Continue to adjust the antenna until you find the best
position with the strongest signal.
5 Press the EXIT button to exit.
Channel
Manual Store
Fine Tune
Signal Strength
LNA : On
Signal Strength
OK
Enter
Return
Channel
Channel List
Auto Store
Manual Store
Fine Tune
Signal Strength
LNA : On
To Next Page