English - 71
Setting Up the Remote to Operate Your DVD
1 Turn off your DVD.
2 Press the
DVD button on your TV’s remote control.
3 Press the
SET button on your TV’s remote control.
4 Using the number buttons on your remote control, enter three digits
of the DVD code listed on page 74 of this manual for your brand of
DVD. Make sure you enter three digits of the code, even if the first
digit is a “0”. (If more than one code is listed, try the first one.)
5 Press the
POWER
button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of DVD. If no
other codes are listed, try each code, 000 through 141.
Note on Using Remote Control Modes: DVD
When your remote control is in
DVD
mode, the volume buttons still
control your TV’s volume.
Setting Up the Remote to Operate
Your Set
Top Box
1
Turn o
ff your STB.
2
Press the STB button on your
TV
’s remote control.
3
Press the SET button on your
TV
’s remote control.
4
Using the number buttons on your remote control, enter three digits
of the STB code listed on page 73 of this manual for your brand of
STB. Make sure you enter three digits of the code, even if the first
digit is a “0”. (If more than one code is listed, try the first one.)
5
Press the POWER button on the remote control.
Your STB should turn on if your remote is set up correctl
y
.
If your STB does not turn on after set-up, repeat steps 2, 3 and 4,
but try one of the other codes listed for your brand of STB. If no
other codes are listed, try each code, 000 through 074.
Note on Using Remote Control Modes: STB
When your remote control is in
STB
mode, the volume buttons still
control your TV’s volume.
Continued...
BN68-01314A-02Eng.indd 72 2007-08-22 ¿ÀÀü 10:38:09
To Next Page
Loading...
