Sanremo D8 - Safety; Safety Labels; Safety Protections; Mechanical Safety Devices

D8
Safety
13
SAFETY
2 SAFETY
2.1 SAFETY LABELS
In all the areas that are dangerous for
the operator or technician, there are war-
ning labels with explanatory pictograms
that must be carefully observed by anyo-
ne preparing to work on it.
IMPORTANT
Failure to comply with the
information on the labels
relieves the Manufacturer from
liability for any direct or indirect
damage to property or persons
caused by improper use of the
machine.
ELECTRICAL HAZARD
Danger: voltage on.
Nameplate located on all live
areas.
Do not work while the voltage
is on.
THERMAL HAZARD
Danger of burning.
Label located on all hot areas.
2.2 SAFETY PROTECTIONS
There are two types of safety systems de-
signed and fitted to the machine:
- mechanical safety devices;
- electrical/electronic safety devices.
2.2.1 MECHANICAL SAFETY DEVICES
The mechanical safety devices are as fol-
lows:
- panels enclosing all electrical/
electronic components and the boiler,
fully closed with screws;
- working surface fitted with grille and
tray to collect fluids;
- controls located on the top part of the
machine, above the dispensing areas;
- safety relief valve on the coffee supply
circuit;
- relief valve on the boiler;
- check valve on the water line.
2.2.2 ELECTRICAL/ELECTRONIC SAFETY
DEVICES
The electrical/electronic safety devices
are as follows:
- thermal breakers on motors;
- safety thermostats to monitor
overheating;