SPA-100 OPERATION MANUAL
56 / 67
Figure 7-7 NI-DAQmx .NET Framework 4.0 Development Support
3. If you want to enable .NET Framework 4.0 development support after
installation, do the following:
(Not required if set at the time of installation)
Control Panel
When you click "Uninstall a program" in "Programs" ⇒, Figure 7-4 is
displayed.
If you right-click ⇒ National Instruments Sofftware and click Uninstall or
Change, Figure 7-9 appears. Select "NI-DAQmx 17.6.0" (the displayed
contents will change depending on the installed version) and click the
"Change" button.
To Next Page
Loading...
