Sanyo PLC-HP7000L User Manual (English)

Other manuals for Sanyo PLC-HP7000L

Owner's Manual98 pages

Specifications27 pages

Dimensional Drawing1 page

Technical Specifications94 pages

Command List1 page

Questions and Answers:

D
ddavidsonAug 10, 2025
Why does my Sanyo PLC-HP7000L Projector remote control not work?
- C
  csheaAug 11, 2025
  There could be several reasons why the remote control for your Sanyo Projector isn't working. First, ensure the batteries are working. Then, check the RC sensor and make sure there are no obstructions between the remote and the projector. Also, confirm you're within the maximum operating range of 16.4’ (5m). Verify that the remote control code matches the projector’s code, and that the Key lock function for the remote control is unlocked. Note that the wireless remote control won't function when the remote control cable is connected. Ensure the ON/OFF switch on the remote is set to “ON,” and that the simple mode is set to Off.
M
Mark AtkinsonAug 18, 2025
Why does my Sanyo PLC-HP7000L Projector power turn off automatically?
- N
  Nicole OnealAug 18, 2025
  Your Sanyo Projector might be turning off automatically due to the power management function's initial settings. Also, if you don't replace the air filter cartridge and reset the filter counter after the replacement icon appears, the projector may turn off automatically. High ambient temperature might also be the cause. Ensure the temperature is within the operating range of 41°F–104°F [5°C–40°C].
E
Edward FernandezAug 26, 2025
What to do if the wireless mouse function does not work on my Sanyo PLC-HP7000L Projector?
- W
  williamselizabethAug 26, 2025
  If the wireless mouse function isn't working on your Sanyo Projector, first check the cable connection between the projector and your computer. Next, verify the mouse settings on your computer. Also, make sure to turn on the projector before turning on the computer.
L
Linda AndersonSep 2, 2025
Why I cannot operate with the side control of my Sanyo PLC-HP7000L Projector?
- N
  Natalie FuentesSep 2, 2025
  If you cannot operate the side control on your Sanyo Projector, it might be because the side control is locked at 'Key lock' under 'Security' of the Setting menu.

Sanyo PLC-HP7000L Specifications

General

Brightness	7000 ANSI Lumens
Contrast Ratio	2000:1
Lamp Life	2000 hours (Normal Mode), 3000 hours (Eco Mode)
Lamp Type	UHP
Projection Size	30 - 300 inches
Resolution	1024 x 768 (XGA)
Projection Method	Front, Rear, Ceiling
Input Connectors	HDMI, VGA, Composite Video