105
Operating the Scale
Equations
Backweight in %: backweight / initial weight* 100%
Loss in weight: backweight – initial weight
Loss in %: (backweight – initial weight) / initial weight * 100%
Calculated loss: (backweight – initial weight) * factor
Ratio 1 in %: (initial weight – backweight) / backweight * 100%
Ratio 2 in %: initial weight / backweight * 100%
Function of the c Key
Weighing Status Press Value deleted Subsequent
sequence c status
Individual Tare weighing –– –
weighing Initial weighing 1 x Tare Tare weighing
Backweighing 1 x Initial weight Initial weighing
2 x Tare Tare weighing
Results displayed 1 x Backweight Backweighing
Consecutive As for individual weighing
individual
weighing
Combined Tare weighing 1 x Previous init.
weighing weigt Initial weighing
2 x Previous tare value Tare weighing
Initial weighing 1 x Tare Tare weighing
Backweighing 1 x Previous Previous
backweight backweighing
Results displayed 1 x Last backweight Backweighing
Serial Tare weighing 1 x Previous tare value Previous tare
weighing weighing
Initial weighing 1 x Previous init. weight Previous initial
weighing
Backweighing 1 x Previous Previous
backweight backweighing
Results displayed 1 x Last backweight Backweighing
Direct Selection of Lot/Sample/Value
When the measured values are dis-
played, you can enter numbers and
letters to:
– change the lot and sample directly
(displayed in the text line)
– directly access the display pages
for samples and values
● Enter lot/sample/value ID
(in this example, »CH0001«,
designates a certain lot)
● Press the corresponding soft key
>
Lot soft key:
The lot corresponding to the ID
entered is displayed (if the lot is not
found, the display page for lots
is shown)
> Sample soft key:
The display page is shown for
samples in the active lot that
contains the sample number entered
> Values soft key:
The values for the sample entered
are shown
> Spl# soft key:
Change samples without the
list function
Toggle between Differential
weighing/weighing: D soft key
Direct Selection of the Weighing
Sequence
You can change the weighing
sequence (individual weighing,
combined weighing, etc.) directly
during measurement by pressing the
Wt.seq key, if this function has been
activated in the Setup menu
[Application parameters: Application 1:
Differential weighing: Weighing
sequence key: Yes]
Soft Key Functions
Create Create a new lot
Lot Select/view the display
page for lots
Ini.wt. Save initial weight
Olni.w Go to initial weighing
function
Result View display page for
results
OResul Go to display page for
results
M-ini Input initial weight value
M-back Input Backweighed
residue
M-tare Input tare value
Delete Delete lot/sample
Values Select/view the display
page
Sample View the display page for
samples
Spl# Select/create sample
data record
Backw. Save backweight value
OBackw Go to backweighing
function
Omit Omit sample
Stat. View display page for
statistics
Tare Save tare value
OTare Go to tare weighing
function
Wg.seq Select weighing sequence
To Next Page
Loading...
Need help?
General