106
List Function for Differential Weighing
The list function has 4 display pages: one each for lots, samples, values and
results.
Display Page for Lots
The display page for lots shows all of the lots that have already been created,
as well as the number of samples in each lot and the processing status of the
selected sample (tare, initial and backweighing). On this display page you
can create, rename, delete and print lots. You can also define a factor for
calculation of loss; for instance, to have weight per unit area calculated (such
as grams per square meter). You can also enter a lot ID alphanumerically to
access a lot directly.
Display Page for Samples
This display page shows the samples contained in a selected lot, as well as the
processing status of the samples (tare, initial and backweighing) and the
sample IDs. You can also enter a sample ID alphanumerically to access
a sample directly.
Display Page for Values
This display page shows the date and time of sampling, as well as the sample
ID and the values measured, for a selected sample.
Display Page for Results
This display page shows the calculated values for a selected sample. These
include backweighed residue, loss, loss calculated using a factor, and the ratio
values. The o symbol indicates the value that is selected for display immediately
following a backweighing procedure. To change this setting, use the q and Q
soft keys to move the highlight bar to the desired value, and press l to confirm.
Display Page for Statistics
This page shows the characteristic data for a lot (date; time; statistics on, for
example, the backweighed residue; number of samples) as well as the
calculated values (mean value, standard deviation).
To select a set of statistics from a lot with different numbers of backweighing
procedures:
Press the l soft key to display the selected set of statistics:
To Next Page
Loading...
Need help?
General