131
Operating the Scale
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed
● Select the “Statistics” application in the Setup menu: press M
FC Models:
§ Select the Application menu:
App soft key
§ Select
Application 3: Press the q soft key and then the O soft key
FCA Models:
● Select
Application parameters: press the q soft key 2 x,
then the O soft key once
● Select
Application 3 (data records):
press the q soft key 2 x, then the O soft key once
● Select Statistics: press the Q or the q soft key
● Select Statistics: press the O soft key
Statistics Automatic ο Off
storage On, first value at stability
On, last value at stability
On, value bet. 70 - 130% at stabil.
Minimum load for None
automatic storage ο 10 digits
20 digits
50 digits
100 digits
200 digits
500 digits
1000 digits
Source of data for ο Application 1
auto storage Application 2
Evaluated values ο Net
Calculated
Net + calculated
Evaluated mode, ο Intermediate evaluation, print
MR function Final evaluation, print
Intermediate evaluation, display + print
Final evaluation, display + print
M+/M– function, ο Off
then tare On
Printout of individual No
components ο Yes
ο = factory setting
see also the “Application Parameters (Overview)” in the chapter entitled
“Configuring the Scale”
● Save settings and exit the Setup menu: press the oo soft key
Additinal Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to Another Application
● Press D
> See the section on the correspon-
ding application program for
further instructions
Setup (Setting Parameters)
● Press M
> See “Configuring the Scale” for
further instructions
Turning Off the Scale
● Press e
> The scale shuts off
> The display goes blank, then
OFF or Standby is displayed with
backlighting
To Next Page
