28
Setup – 1 and 5 – see previous pages
Scale Menu
5 Interface 5 5 Communication 5 5 1 o SBI
mode 5 5 2 XBPI
5 5 4 YDP01IS
5 5 5 YDP02
5 5 6 YDP03
5 5 7 YDP01IS Label printer
5 5 10 YDP02IS
5 5 11 YDP02IS Label printer
5 5 14 YDP04IS
5 5 15 YDP04IS Label printer
5 6 Network address 5 6 1 o 0
5 6 x 1 through 30
5 6 32 31
6 Print in 6 1 Manual/auto 6 1 1 Manual without stability
weighing mode print mode 6 1 2 o Manual with stability
6 1 4 Automatic without stability
6 1 5 Automatic at stability
6 1 6 Automatic after weight change**
6 2 Stop auto print 6 2 1 Press p key or enter <ESC P>
6 2 2 o Not possible
6 3 Time-dependent 6 3 1 o 1 display update
auto print 6 3 2 2 display updates
6 3 4 10 display updates*
6 3 7 100 display updates*
6 4 Print on request, 6 4 1 o Off
then tare 6 4 2 On
8 Extra functions 8 1 Menu 8 1 1 o Change parameters
8 1 2 Read parameters
8 2 Acoustic signal 8 2 1 o On
8 2 2 Off
8 4 External switch 8 4 1 o p key
function 8 4 2 t key
8 4 3 Calibrate/adjust [isoTST]
8 4 4 N F1 function key
8 4 5 c key
8 4 6 N F2 function key
8 5 Display 8 5 1 o On
backlighting 8 5 3 Auto off after 4 minutes
8 6 Power-on mode 8 6 1 o Off/on/standby
8 6 2 Off/on***
8 6 4 Auto on
8 7 Automatic shutoff 8 7 1 After 4 minutes
8 7 2 o Off
8 10 ISO/GLP/ 8 10 1 o Off
GMP printout 8 10 2 Only for calibration/adjustment
8 10 3 Always on
9 Reset menu 9 1 Factory settings 9 1 1 Restore
9 1 2 o Do not restore
9 1 9 Toggle to MP8 interface emulation
* = not applicable to verified scales
** = auto print when load change is >10 d; no printout until residual difference in load value is < 5 d
*** = not on FC ... EDE models
Menu level 1
Menu level 2
Menu level 3
Factory setting
Menu level 4
To Next Page
Loading...
