66
Printing an ISO/GLP/GMP-
compliant Record
In the Setup menu, you can configure
whether
– no ISO/GLP/GMP-compliant
record is printed
(
Off, [8-10-1])
– an ISO/GLP/GMP-compliant
record is printed only after
calibration/adjustment
(
Only for
calibration/
adjustment, [8-10-2])
– every printout is an
ISO/GLP/GMP-compliant record
(Always on, [8-10-3])
Undoing All Parameter Changes –
Reset Function
There is a factory setting for each
parameter. In the Setup menu, you
can configure whether
– factory settings are restored after
exiting Setup (Factory
settings, [9-1-1])
To Next Page
Loading...
Need help?
General