87
Operating the Scale
Examples
Practical Example P1: Weighing in Percent with Reference Weight Taken From Weight on Scale
Settings (changes in the factory settings required for this example):
Setup: App(lication parameters): Application 1: Weighing in percent
FCA Models: Setup: Printout: Application-defined output: Autoprint upon initialization: All values
Step Key (or instruction) Display/Output
1. Delete previous setting if necessary c
2. Prepare a container Place the empty container
for the parts on the scale
3. Tare the scale t
4. Place the reference weight Place weight equal
on the scale to reference weight in
(here: 1821.48 g = 100%) the container
5. Initialize the scale
Start soft key
6. Unload the scale Remove reference
sample from the container
7. Determine the percentage Place sample to be
of an unknown weight measured in the container
8. If desired, print percentage p
(here: 98.37%)
To Next Page
Loading...
Need help?
General