90
Preparation
§ Turn on the scale: Press e
> Sartorius logo is displayed
§ Select the “Animal weighing” application in the Setup menu: Press M
FC Models:
§ Select the Application menu: Press the
App soft key
§ Select
Application 1: O soft key
FCA Models:
§ Select
Application parameters: press the q soft key 2 x,
then the O soft key once
§ Select
Application 1 (basic settings): press the O soft key
§ Select
Animal weigh.: Q or q soft key repeatedly
§ Confirm Animal weigh.: O soft key
Animal weighing Animal activity Calm
(Averaging) Normal
Active
0.1% of animal/object
0.2% of animal/object
0.5% of animal/object
1% of animal/object
2% of animal/object
o 5% of animal/object
10% of animal/object
20% of animal/object
50% of animal/object
100% of animal/object
Start Manual mode
o Automatic mode
Minimum load for None
automatic storage 10 display increments
20 display increments
50 display increments
o 100 display increments
200 display increments
500 display increments
1,000 display increments
Decimal places in None
calculated result 1 decimal place
o 2 decimal places
3 decimal places
4 decimal places
5 decimal places
6 decimal places
Printout None
o Average weight only
Average and calculated
o
= factory setting
see also the “Application Menu (Overview)” in the chapter entitled
“Configuring the Scale”
§ Save settings and exit the Setup menu: Press the oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during
alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
§ Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Toggling to the Next Application
§ Press D
> See the section on the
corresponding application
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale”
for further instructions
Turning Off the Scale
§ Press e
> The scale shuts off
> The display goes blank
To Next Page
Loading...
Need help?
General