Sartorius Factory Series User Manual

94
Factory Settings of the Parameters
Print application parameters
(automatic output of application
parameters): All values
Line format:
for other apps/GLP
(22 characters)
Soft Key Functions
Comp.xx Store component
Add.xx Store component in
additive weighing mode
Div. Store divisor before
or during component
weighing
Recalc Start correction proce-
dure for recalculation
UAdd./ Toggle display between
UComp component weight and
total weight (additive
mode)
Comp. Store numeric input for
recalculation
Minus Set value given for the
formulation
Plus Set value given for the
formulation
Preparation
● Turn on the scale: press e
> The Sartorius logo is displayed
● Select the “Recalculation” application in the Setup menu: Press M
FC Models:
● Select the Application menu: Press
App soft key
● Select Application 1: O soft key
FCA Models:
§ Select
Application parameters: press the q soft key 2 x,
then the O soft key once
§ Select
Application 1 (basic settings): press the O soft key
● Select
Recalculation: Q or q soft key repeatedly
● Confirm Recalculation: o soft key
● Save settings and exit the Setup menu: press the oo soft key
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric
input), and
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
§ Press the
isoTST soft key
> See “Calibration/Adjustment”
for further instructions
Taggling to the Next Application
§ Press D
> See the section on the
corresponding apllication
program for further instructions
Setup (setting parameters)
§ Press M
> See “Configuring the Scale”
for further instructions
Turning Off the Scale
§ Press e
> The scale shuts off
> The display goes blank

Sartorius Factory Series Specifications

General

Brand	Sartorius
Model	Factory Series
Category	Scales
Language	English