95
Operating the Scale
Practical Example
When weighing in formulation components, the second component is over-poured.
Settings (changes in the factory settings required for this example):
Setup: App(lication parameters): Application 1: Recalculation
Step Key (or instruction) Display/Output
———————————————————————————————————————————————---——
1. Delete previously stored values, c
if necessary
2. Place container for filling Place empty container
components on the scale on the scale
3. Tare t
4. Add the first component Weigh the first component
into the container
5. Store component Press the
Comp.1
6. Add the second component Weigh the second
component into the container
7. Start recalculation, because Recalc soft key
10.73 g were poured rather
than 10.60 g
8. Either press the minus Minus soft key repeatedly
key to correct the value …
Comp1 + 25.08 g
RECALC.: Store
RECALC.: Store
RECALC.: Store
RECALC.: Store
RECALC.: Store
RECALC.: Correcting
RECALC.: Correcting
Recalc
Recalc
s2
s2
s2
s2
To Next Page
Loading...
Need help?
General