Installation 21
Fig. 5-13 | Connection with external pressure sensor for WIT
5.6.1 Inserting Paper Roll To insert or change the paper roll, lift the cover off the paper feed. Pull the feed
Ribbon Cartridge mechanism out of the assembly and push the cover to the left and lift it out
of its attachments. Now lift the paper feed mechanism out of the Sartocheck
®
4 plus
housing.
Insert a new paper roll into the paper slot and slide the paper feed mechanism back
into the housing. Thread the end of the paper through the slot of the paper feed.
Make a final check to ensure that the feed mechanism is locked in place.
Close the printer cover and secure the splashguard. Check to make sure that the
splashguard is locked in place.
To change the ribbon cartridge (when the feed mechanism is pulled outwards)
lift the previously installed cartridge out of the paper feed and insert a new one.
Apply slight pressure to lock the cartridge in.
Sartocheck 4 plus
To Next Page
Loading...
