10 Operating Instructions YDP30 | YDP30-NET
Installation
4 Installation
4.1 Scope of Delivery
Item Quantity Purpose
Device 1
Power supply unit, type
WDS060240
1
Country-specific power
supply cable
1
YDP30 only
Printer connection
cable, type USB
1
Printer connection
cable, type RS232
1
Winding roller 1 Used to wind the
ink ribbon
Operating Instructions 1
4.2 Selecting an Installation Site
Procedure
t Make sure that the following conditions are met at the
installation site:
Condition Features
Ambient
conditions
Suitability tested (see Chapter “13.2
Ambient Conditions at the Installation
Site”, page 23)
Setup surface − Stable, even surface with little
vibration
− Sufficient space for the device.
4.3 Unpacking
Procedure
t Unpack the device.
t Install the device at the intended installation site. The
device must not be dropped or shaken.
t We recommend you keep the original packaging for a safe
and proper return of the device, e.g. for repairs.
4.4 Acclimatizing
When a cold device is brought into a warm environment: The
temperature difference can lead to condensation from
humidity in the device (moisture formation). Moisture in the
device can lead to malfunctions.
Procedure
t Allow the device to acclimatize for approx. 2 hours at the
installation site. The device must be disconnected from the
power supply during that time.
5 Getting Started
5.1 Connecting the Power Supply
Procedure
t
WARNING Severe injuries may be caused by using
defective power supply cables! Check the power supply
cable for damage, e.g., cracks in the insulation.
t If required: Please contact Sartorius Service.
t Check whether the country-specific power plug matches
the power connections at the installation site.
t If required: Please contact Sartorius Service.
t Check whether the voltage specifications on the
manufacturer's ID label match those of the power supply at
the installation site.
t If the input voltage is too high: Do not connect the
device to the power supply.
t Please contact Sartorius Service.
t Connect the power supply unit connection cable to the
“Power Supply” connection.
t Connect the power supply cable to the power supply unit
and the power supply at the installation site. The power
outlet must be easy to reach.
To Next Page
Loading...
Need help?
General
