Satec System 295 - Page 149

Appendix B Programmable Parameters 141
Table B-7 Setpoint Trigger Parameters
Group Parameter Unit Range À Condition
label Label Name
Á
label
Au.C Auxiliary current mA/A 0 to Iaux max
nEU.C Neutral current A 0 to Imax
FrEq Frequency  Hz 0 to 100.0
U.Unb Voltage unbalance % 0 to 300
C.Unb Current unbalance % 0 to 300
Ar.Ph
Average values per phase
GE/LE/Eq/nE
U 1 Voltage L1/L12 V 0 to Vmax
U 2 Voltage L2/L23 V 0 to Vmax
U 3 Voltage L3/L31 V 0 to Vmax
cur1 Current L1 A 0 to Imax
cur2 Current L2 A 0 to Imax
cur3 Current L3 A 0 to Imax
Ac.P1 kW L1 kW -Pmax to Pmax
Ac.P2 kW L2 kW -Pmax to Pmax
Ac.P3 kW L3 kW -Pmax to Pmax
rE.P1 kvar L1 kvar -Pmax to Pmax
rE.P2 kvar L2 kvar -Pmax to Pmax
rE.P3 kvar L3 kvar -Pmax to Pmax
AP.P1 kVA L1 kVA 0 to Pmax
AP.P2 kVA L2 kVA 0 to Pmax
AP.P3 kVA L3 kVA 0 to Pmax
PF1 Power factor L1 -1.00 to 1.00
PF2 Power factor L2 -1.00 to 1.00
PF3 Power factor L3 -1.00 to 1.00
th.U1 Voltage THD L1/L12 % 0 to 100.0
th.U2 Voltage THD L2/L23 % 0 to 100.0
th.U3 Voltage THD L3 % 0 to 100.0
th.C1 Current THD L1 % 0 to 100.0
th.C2 Current THD L2 % 0 to 100.0
th.C3 Current THD L3 % 0 to 100.0
HFc.1 K-Factor L1 1.0 to 999.9
HFc.2 K-Factor L2 1.0 to 999.9
HFc.3 K-Factor L3 1.0 to 999.9