INTEGRA SATEL
27
6.8 C
ODES AND USERS
Access to the control functions of the panel is possible after entering a proper code (4 to 8
digits) and pressing the [
*
] or [#] key. Three basic code types are distinguished:
1. Service code – this code identifies the user with special authority: he can control all
partitions and open all doors controlled by the control panel; he has access to most of the
control panel functions (except for the S
ERVICE ACCESS
,
V
IEW MASTERS
,
C
HANGE PREFIX
,
U
SERS
and some options
– see Description of user functions), and may enter and delete
the object master users. Factory preprogrammed service code: 12345.
2. Master user (supervisor) code – this code identifies the user with the highest authority in
the object. The master user has access to all partitions within his object and determines
the service code access to the system. There is a function, available to the maser user
only, which enables the service access (see Description of user functions: S
ERVICE
ACCESS
,
C
HANGE OPTION
). The default master user code for the first object is 1111. Other
master user authority levels may be limited by the service (installer). If several objects are
defined in the system, each object can have its own master user code. This user has the
right to enter new users into the system.
3. User code – the remaining codes entered in the system by master users or users
(authorized to edit the user). These are codes for everyday operation of the system. The
number of available codes depends on the control panel size:
– INTEGRA 24: 16
– INTEGRA 32: 64
– INTEGRA 64: 192
– INTEGRA 128: 240
Notes:
• Each user of the system (except for the master) can have a telephone code assigned to
him – see section "Answering Phone Calls".
• Service code is rejected by the control panel when the service access is disabled. The
master user can enable the service access to the alarm system temporarily or
permanently.
• If there is no master user code in the system (all master users are removed), the service
access to the system is unlimited.
• It is recommended that the master user code not to used everyday (due to possibility of
unauthorized capture). The master user should enter for himself an ordinary user code,
with “strategic" functions disabled, and he should use it for everyday work. The main
reason for this is to protect access to the service mode and prevent entering codes by
unauthorized persons.
Additionally, a code can be assigned a specific control function which will be executed after
entering the code and pressing the [#] key (see: Description of user functions
Æ
U
SERS
) or
after using the proximity card assigned to the given code.
The installer (using the service code) grants codes and names to the master users (one
master user per each object), as well as he defines their rights.
The master user has the right to enter ordinary system users. He grants them the authority,
type and defines the partitions, to which the users will have access. Also, the ordinary user
may be authorized to enter new users. The new user may only have access to the functions
and partitions which are accessible to the user who enters the new code.
Note: If the entered user is authorized to change the code, he should change it after the first
use of his code. The control panel reminds the user to perform this operation by
means of a prompt on the keypad display and an audible signal PROG.
To Next Page
Loading...
