User Manual INTEGRA
34
• Now the control panel waits for the (two-digit) switch number to be entered. Entering the
telephone number from the telephone keypad will switch the relay status to the opposite
one. Three short beeps mean that the relay is switched off and four short and one long
beeps - that the relay is switched on. Each time you enter the same number, the relay
status is changed to the opposite one.
• It is possible to move back to the partition status indication mode by pressing in turn the [1]
and [#] keys.
• Pressing in turn the [0] and [#] keys will exit the function and terminate the telephone
connection.
6.15 O
THER FUNCTIONS USING TELEPHONE LINE
If functions of the control panel telephone communicator are used in the alarm system, then
the facility public line should be directly connected to the control panel, and all telephone sets
should be installed after the control panel. Therefore, no signals are heard in telephones
connected after the control panel, when the panel is on the telephone line. This situation may
frequently occur in multi-partition systems, when monitoring is activated (a special reporting
system intended for sending information on the object status to a security agency, working
independently of the aforementioned user notification system). Moreover, the control panel
will disconnect telephone conversations to capture the telephone line in order to transmit an
information on a new event. It should be noted that such connections do not last very long
(from a few seconds to one minute, depending on the selected format of data transmission).
Another function, when the control panel occupies the telephone line, is programming by
telephone (“downloading"). The service may initiate this function by phone. During data
interchange with the service computer, the telephone line may be occupied for a long time.
Even if the programming is initiated by the user, the service may suspend communication
with the control panel to reduce the connection costs, and then resume it without involvement
of the user.
Note:
• The downloading function will be automatically stopped, if 255 minutes have elapsed since
the last use of the DLOADX program, and the service access was blocked or expired in
the meantime.
• The control panel is protected against any attempts to scan the code – after three
consecutive attempts to get access to the panel using wrong codes within one telephone
communication session, the function of answering the modem signals will be disabled for
30 minutes.
7. U
SER
F
UNCTIONS
7.1 M
AIN MENU
Presented on the next few pages is menu of all the user functions. These functions are made
available by the control panel in LCD keypad on entering the service code, master code or
normal user code and pressing the [#] or [
*
] key. Some of the specified functions are only
accessible to a selected code type. All details concerning the particular functions are
described hereunder. Function descriptions are arranged in the order corresponding to that of
the menu available on entering the [CODE][
*
].
To Next Page
Loading...
