User Manual INTEGRA
60
[1][1][1][1][#] Enter the user code (factory set master user code for Object 1).
You can also enter the code of any user who has access to Partition 2 and is authorized for disarming.
By pressing [#] or X,
all partitions armed and accessible to the user will be disarmed
.
Note: If only one partition is armed, it will be disarmed immediately after pressing the [#] key (and the end
message will be displayed). If an alarm is signaled for the partition, it may be cleared together with
disarming.
T Indicate the Disarm selected function.
X or [#]
Call the function
.
S or T Scroll through the list with
partition
names. Press one of these keys as many times as needed to
display the name of the required
partition
(
partition
2 – Book-keeping).
After the function is called, the control panel will display names of partitions (factory set or entered by the
installer) which may be disarmed by the user. Press X
to move to the graphic mode of
partition
selection
(selection in the graphic mode is done in the same way as when arming).
[3] Mark the partition selected for disarming (
mark at the right-hand side of display) using any
numeric key).
You may select for disarming (mark) any number of armed partitions which are accessible to you. You may also
deselect partitions selected earlier.
[#] End of selection and disarming of all partitions marked.
DISARMING (part II: [CODE][
*
])
[1][1][1][1][
*
]
Enter code – call the user function menu.
[#] or X
Select the function indicated with arrow – you will be taken to the stage of partition selection for
disarming, as described in detail in the first part of this example
.
Note: If only some partitions in the object are armed, the following texts will appear on the display:
In this case you should act in the same way as when all accessible partitions are armed.
Á
Disarm all
Disarm selected
What to disarm:
Workroom 1
What to disarm:
Book-keeping
System disarmed
Á
Disarm
Change own code
What to disarm:
Workroom 1
Á
D
To Next Page
Loading...
