INTEGRA SATEL
29
Note: The same card/chip cannot be assigned to two users.
6.10.2 Deleting cards/DALLAS chips
In order to delete the proximity card/DALLAS chip assigned to the administrator/user:
1. Start the "Erase prox. card"/"Erase chip" function.
2. After the card/chip number is displayed, press the key [1].
Note: By using the "Erase prox. card"/"Erase chip" function you can check the number of the
card/chip.
The card will not be actually added/deleted until completion of the user
adding/editing procedure, i.e. until the function is quitted by pressing the [
*
] key
and the introduced changes are saved by pressing the key [1].
6.11 S
YSTEM ARMED MODE
Armed mode is the basic status the control panel is designed for. In this mode, the control
panel detectors monitor the protected object, and any violation of the protected partition is
signaled by the control panel with all available means (as programmed by the installer). The
INTEGRA control panel enables individual control of armed status in each partition of the
object. A single partition, several partitions and/or all partitions may be armed.
The user can arm the system using one of the following ways:
• entering [CODE][#] in LCD keypad – all partitions or some selected partitions only can
be armed;
• entering [CODE][#] in partition keypad – the partition to which the keypad is assigned
can be armed;
• entering [CODE][
*
] in LCD keypad and choosing "Arm" function – selected partitions
can be armed; if any of the partitions controlled by the keypad is armed, this is the only
way to arm of the other partitions;
• entering [0][#] in LCD keypad – all installer programmed partitions will be armed;
• entering [0][#] in partition keypad – the partition to which the keypad is assigned will be
armed;
• holding card in the proximity of the reader for approximately 3 seconds – the partition to
which the reader is assigned will be armed;
• holding DALLAS chip in the reader for approximately 3 seconds – the partition to
which the reader is assigned will be armed.
Notes:
• The control panel will not arm the partition(s) in the following cases:
− at least one zone with active P
RIORITY
option is violated in the selected partition;
− the options R
EQUIRED
S
YSTEM
R
ESET AFTER VERIFIED ALARM
,
D
O NOT ARM IF TAMPER
, D
O
NOT ARM IF BATTERY TROUBLE
, D
O NOT ARM IF TROUBLE
, D
O NOT ARM IF OUTPUTS TROUBLE
and D
O NOT ARM IF REPORTING TROUBLE
are enabled and at least one of such situations
takes place.
In case of arming by means of the LCD keypad, a list of causes which prevent arming will
be displayed. Press the [
*
] key to cancel the arming. Press the [#] key to repeat the
attempt of arming (without having to select partitions or armed mode status). If the cause
which prevented arming has been in the meantime removed, the partition will be armed.
Otherwise, the list of causes which prevent arming will be displayed again.
To Next Page
Loading...
